The inner tube of this product fully automatic circuit board disassembly machine adopts 45mm steel plate with corresponding thickness of 6mm and the corresponding production technology; it has the characteristics of high temperature resistance, wear resistance, safety and reliability, stable performance, high accuracy, durability and other characteristics. It is an electronic circuit An indispensable ideal tool for the production industry of the board industry.
1. The automatic circuit board dismantling machine is equipped with a high-power reduction gear motor, a high-power flame burner, which can quickly raise the temperature from room temperature to 270 ° C, only about 20 minutes (there will be slight differences depending on the volume of the tin furnace).
2. Automatic circuit board dismantling machine is suitable for disassembling various types of circuit boards (for example: computer motherboards, television boards, home appliance boards, etc.)
3. The inner cylinder of the fully automatic circuit board disassembly machine uses a 45 mm steel plate with a thickness of six millimeters and the corresponding production technology; it has the characteristics of high temperature resistance, wear resistance, safety and reliability, stable performance, high accuracy, and durability.
4. The data set by the machine can be stored for a long time without being affected by shutdown and power failure.
1. Working voltage: 380 ± 10V (can be customized 415V 440V)
2. Working temperature: 0-55 degrees
3. Working temperature: <90% RH without condensation
How to use:
1. Check whether the power is installed and whether the main switch is powered on.
2. Open the inner cylinder lid, put the circuit board into the cylinder, and fill it with eight minutes. After the lid is installed, close the outer cylinder lid together.
3. Please go to the control box and adjust the temperature controller to 130 ℃ (the highest temperature can be adjusted to 200 ℃, according to the circuit board to adjust the temperature)
4. Turn the switch, normally open switch and vibration switch together, and adjust the black knob switch between 8-9.
5. After the burning time is about 15-25 minutes, observe whether the electronic components have dropped. When it is almost finished, adjust the temperature controller to 0 ° C. Turn the switch, the vibration switch and the normally open switch can not be turned off, and then idling 5 minute.
6. After 5 minutes, turn off the rotary switch, open the outer tube and inner tube cover. After opening the inner tube cover, close the outer tube cover and turn on the rotary switch, and the circuit board will automatically fall out.
7. Check whether the circuit board after disassembly is disassembled cleanly, whether there are any electronic components or tin not removed. If the disassembly is not clean, please increase the firepower of the fire burner when disassembling the second time. can.
1. Do not turn on the power when the machine is turned on. Check whether the fuse is open or the socket is plugged in.
2. Once the temperature controller is displayed at 400 ℃, please replace the temperature control line.
3. When the temperature rises slowly, please check whether the gas tank is without gas.
1. Check if the switch is open before operation.
2. During operation, it should be observed whether the heating tube is all on and the damage is not caused when the green light of the temperature controller is on.
3. During operation: If the burning time is too long and the circuit board is scorched and the inner cylinder is on fire, remember that you do not need to be nervous and you cannot open the lid. You only need to adjust the temperature controller to 0 ° C and the motor speed to the fastest. The minute temperature is low, the smoke is naturally reduced, and then the circuit board can be released.
Rated power 30kw
Temperature range 0-270 ℃
Disassembly efficiency (hourly) 150KG